How to create a Result Type in a Notification

To display a new Result Type in the notification we need to create a new Lookup Type in the workflow builder and Lookup Codes that you want to display in the notifications.
Steps to Create a New Lookup Type and Assign it to a Notification
1. Right Click on Lookup Types -- Select New
   

2. New Lookup Type will be displayed under the Lookup Types 
     

3. Right Click on the New BPA Approval Lookup that we created and Select “New Lookup Code”

    
4. Enter the following Properties for the New Lookup Code and Click Apply and OK
     

5. Create a new Lookup Code for “Reject” similarly as did for “Approve”
       

6. To be able to see these Lookup Codes as buttons in the Approval Notification, Create a New Message with the Result Type as BPA Approval Lookup
7. Create a new Message and in the Result Tab, Enter the following Properties as shown below.
     

 

8. Click Apply and OK.

9. Now assign this Message and Result Type to the Notification where you want to have this Results Displayed as Buttons inside the Notification
   

10. Include this Notification in your Process and when Run, you would be able to see the selected Resulted type of Buttons in the Notification

    

Delete Icon Next to a Row in Advanced Table

Delete Icon will be used to delete a row in the Advanced Table. An Icon can be handled in the Table after all the columns and when Clicked upon this Icon, would delete the entire row from the Table and DB. To achieve this functionality, we need to perform the following steps.
1. Create an Advanced Table and All your Columns required in that Table.
2. To be able to display the Delete Icon at the end, Right Click on the Advanced Table --> New --> Column
3. Right Click on the New Column created and Select --> New --> Item
    Set the following properties to this Item..

4. Right Click on Column Components --> Select Sortable Header 

5. Click on Sortable Header and in the Properties set the Prompt as "Delete".

Now we have the Front End Icon is ready. If you run the Page, You will be able to see the Icon in the End of the Columns of the Table. Now we need to Handle this Event in back end to delete the row next to the Delete Icon pressed.

6. Write the following code in the ProcessFormRequest method of the Page Controller.

7. Include the following code in the AMImpl,java file of the Attached AM.

Rebuild the project and Run the Page. You should be able to delete the Row When Clicked on the Delete Icon next to that row.